Samsung OfficeServ ITP-5112L User Manual

Also see for DS 5000 Series: User guide User instruction User guide User manual Quick reference guide

Contents

11• The [0]-[9] dial buttons are used to directly choose a menu, or sub menuoptions.• The [ENTER] button in the navigation button assembly is used when saving amodification.• The [MENU] button in the navigation button assembly is used to to displaythe IP Setup Main Menu.• The [END] button in the navigation button assembly is used when cancelingor editing the modification, or existing programming.• The [CANCEL] button in the navigation button assembly is used to go back tothe previous screen or to delete the last digit of a displayed option value.MENU STRUCTUREThe IP SETUP MENU is configured as follows:1. SYSTEM EASY WIZARDThis option will guide you through setting up all required parameters for con-necting the ITP keyset to your system.2. SYSTEM INFORMATION1. Version Info: Provides boot rom, software, DSP, and hardware versioninformation.2. Network Info: Displays network mode, IP address of phone, network, andgateway information.3. Netmask4. GatewayNote that items 2 to 4 are only displayed when setting Manual IP.3. NETWORK SETUPThis menu allows you to individually setup the same parameters found in theEasy Wizard.4. LOAD & UPGRADE SETUP1. Upgrade TFTP Server:The IP address of the TFTP server containing the ITPsoftware.2. Upgrade Start: Starts the ITP software upgrade process.5. SYSTEM SERVER SETUP1. Server IP Address: The main processor’s IP address.2. Server ID: The ID assigned to your ITP (see your phone administrator forthis information).3. Server Pass: The password assigned to your ITP (see your phone adminis-trator for this information).ITP-5112L SETUPINITIALIZING THE ITP-5112LInitially the ITP-5112L IP keyset will need to be setup to operate within the usersnetwork.The Setup Menu is also used to make changes to the keyset, in the eventthat the system information should change. The option chosen via scroll buttonwill be highlighted.The station numbers will be automatically set by the OfficeServ 100, theOfficeServ 500, or the OfficeServ 7000 Series systems once the necessary infor-mation has been entered into the IP keyset. Enter ID and password of the server,as described below to register the phone.See your system administrator for specific Network and Server addresses. Theaddresses necessary to set up the ITP-5112L are:• IP Address of Station• Network Gateway Address• IP Address of System’s main processor• User ID• PasswordIP SETUP MENUTo get to the SETUP MODE unplug the power cord from the ITP. Press and holdthe MENU button while you plug power backinto the phone. Release the MENU buttonwhen you see the SETUP SCREEN. If you havea PoE (Power over Ethernet) connection, thesame procedure can be done by unpluggingand plugging the Ethernet cable into thephone while pressing and holding the MENUbutton.Once the CONFIGURATION MENU is dis-played, you can move to each menu in the SetUp by using the navigation buttons and [1]-[9] dial buttons of the ITP-5112L IPphone.• The UP and DOWN directions buttons in the navigation button assembly areused to move the highlighted bar up or down to the desired option.• The LEFT and RIGHT buttons in the navigation button assembly are used tomove the highlighted bar left or right, to the desired option, move to a submenu and if a menu is at the last line, that menu option will be executed.Configuration*1.System Easy Wizard2.System Information3.Network Setup4.Load & Upgrade Setup5.System Server Setup6.Factory Reset7.Reboot10