Planning24 Installation ManualDNS SetupUse the DNS Setup section to set the receiving figures of the KX-TDA0480 starting addresstranslation.When an H.323 Gatekeeper is not used in the IP Gateway network, the KX-TDA0480 internalDNS are used to perform telephone number-to-IP address translation.See Appendix A3 of this document.SNMP SetupIf an SNMP compatible network management system is present, use the SNMP Setup sectionof the worksheet to record information about available Trap IP addresses and the facility'sCommunity name.SNMP Simple Network Management Protocol is a TCP/IP Protocol suite Application Layerutility that provides a mechanism to manage and control network equipment from a centralconsole system. The KX-TDA0480 report any error codes or fault codes to the central console(Network Management System NMS) by sending out Traps.Trap IP 1 (SNMP_TRPDST)Record the IP address for the first Trap Transmission facility. The IP address must conform toInternet Protocol addressing requirements, e.g. nnn.nnn.nnn.nnn, where nnn = a value of 0 to255 excluding 0.0.0.0 and 255.255.255.255.There is no default value for this field.In the sample, there is no Trap 1 IP address.Common Configuration WorksheetGroup Name(s)DNS SETUPSearch Digits:(2)SNMP SetupTrap 1 IP: Trap 2 IP:Trap 3 IP: CommunityName: (public)GatekeeperGatekeeper 1 IP: Gatekeeper 2 IP:Notify E-mailSNMP PrimaryIP:SNMP SecondaryIP:E-mail 1: E-mail 2: