Panasonic KX-TDA0480 Installation Manual

Also see for KX-TDA0480: Getting started Getting started guide Getting started

Contents

Panasonic KX-TDA0480 Installation Manual Manual pdf 121 page image

Logical InstallationInstallation Manual 1214.9.2 Configure a Gatekeeper UnitUsing the Maintenance Console Software to configure network Gatekeepers is very similar tothe methods used to configure a Gateway but the number of configuration parameters isconsiderably fewer.The Maintenance Console Software display uses a set of tabbed folders to organise theconfiguration process. Each of these folders contains fields in which configuration data areentered.The data to be entered should have already been identified and recorded on a Unit SetupWorksheet for the unit being configured.Much of the data recorded during the unit configuration process is critical to the properoperation of the equipment and care must be taken to avoid errors.As discussed earlier, when a unit is selected and the Edit Data command is used, theMaintenance Console Software asks if a saved file is to be edited or if the file in the unit shouldbe downloaded.If the saved file is to be edited, the Maintenance Console Software displays a dialogue box inwhich the file to be edited can be selected. See section 4.7 Create New Units to review thisprocess.Once the file to be edited has been selected, the Maintenance Console Software displays theconfiguration folders for the Gatekeeper unit.Each of these folders is discussed below.• Only the Gatekeepers can be configured using the MCS. See the manufacturer'sdocumentation for other Gatekeepers.• When an H.323 Gatekeeper address is configured within the IP Gateway network, it takesprecedence over all other network management facilities. The KX-TDA0480 internal DNSsettings will be ignored.