PlanningInstallation Manual 19Gatekeeper for Maintenance Console Software procedures to configure this information in theKX-TDA0480.A reproduction master for this worksheet is included in Appendix A8.Group NameUse the Group Name field to assign a group in which to create and store the KX-TDA0480 inthe Maintenance Console Software. Subgroups can also be created. The procedure for creatingGroups is discussed in Section 4.6 of this document.Each KX-TDA0480 must be assigned to a Group. The New Group command is used to enterthis information in the Maintenance Console Software. Although the Maintenance ConsoleSoftware requires that this be done before units (Gateways) can be defined, it is used for unitidentification only and is not recorded in the unit's configuration file (OFDD.VHO).DNS information is stored in the unit's DNS.DAT file.The Group Name field allows for entry of an unrestricted alphanumeric string.For convenience, the Group Names in the sample worksheet are designated as the names of thecities in which the units will be installed.• This worksheet contains all of the information needed to initialise a network's KX-TDA0480 using the Maintenance Console Software Unit Setup Wizard.• If this setup information is uploaded to each unit and the units are rebooted, it is possible toperform all remaining configuration tasks remotely using the Maintenance ConsoleSoftware.Group Name Unit Name Unit IP Address Subnet MaskIP AddressRoute IPAddress 1Route IPAddress 2Signalport no.IP Gateway Network Units List WorksheetNew YorkNew YorkSan FranciscoSan FranciscoLos AngelsLos AngelsNY01NY02SF01SF02LA01LA02133.149.1.91133.149.1.92206.184.223.95206.184.223.96206.45.11.34206.45.11.35255.255.255.0255.255.255.0255.255.255.0255.255.255.0255.255.255.0255.255.255.0133.149.1.1133.149.1.1206.184.223.1206.184.223.1206.45.11.1206.45.11.1172017201720172017201720