Panasonic Eco Solutions Nordic ABMEW01457 Rev: - Operating Instructions Fire alarm system EBL512, V2.7.x421 EBL512 settings download ___________________ 8721.1 Control Units in a TLON network ____________________ 8722 Restart ___________________________________ 8822.1 Boot menu _______________________________________ 9023 Access ____________________________________ 9224 Perform monthly test (H1) ___________________ 9325 Disable or re-enable (H2) ____________________ 9625.1 Disable zone (H2/B1) ______________________________ 9725.2 Disable zone / address (H2/B2) _______________________ 9825.3 Disable control output (H2/B3) _______________________ 9925.4 Re-enable zone (H2/B4) ___________________________ 10125.5 Re-enable zone / address (H2/B5) ____________________ 10225.6 Re-enable control output (H2/B6) ____________________ 10325.7 Re-enable non-reset zone / address (H2/B7) ____________ 10525.8 Disable / Re-enable all control, exting. and ventilation outputs(H2/B8) ______________________________________________ 10625.9 Disable / Re-enable alarm devices (H2/B9) ____________ 10726 Set calendar and clock (H3) _________________ 10826.1 Daylight saving time ______________________________ 10927 Present system status on display and printer (H4)11027.1 Disablement (H4/U1) _____________________________ 11027.2 Disablement by time channel (H4/U2) ________________ 11127.3 Doors open (H4/U3) ______________________________ 11227.4 Activated 2-zone/address dependent zone/address (H4/U4) 11327.5 Sensor values (H4/U5) ____________________________ 11427.5.1 Reset of a week average sensor value _____________ 11627.5.2 Algorithm setting via menu H4/U5 _______________ 11727.6 Sensors activating SERVICE signal (H4/U6) ___________ 12227.7 Event log (H4/U7) ________________________________ 12327.8 Configuration (H4/U8) ____________________________ 12428 Service (H5) ______________________________ 12528.1 Access code for service (H5) _______________________ 12628.2 Calibration of supervised outputs (H5/A1) _____________ 12728.3 Sensitive fault detection mode (H5/A2) _______________ 12828.4 Direction for communication on COM-/BS4-loop (H5/A3) 12928.5 Show information about Site Specific Data (H5/A4) _____ 13028.6 Display current consumption in unit (H5/A5)___________ 13128.7 Display current consumption COM-/BS4-loop (H5/A6) __ 13228.8 Display statistics for COM-loop (H5/A7) ______________ 13328.9 Select unit on COM-loop to use for trigging (H5/A8) ____ 13428.10 Activate address setting mode for DU (H5/A9) _______ 13528.11 Change access code for PC-communication (H5/A10) __ 13628.12 Change access code for service (H5/A11) ___________ 137
