4-22 Configuring Your ServerSee the table below for the items.Option Parameter Description Your SettingUser Password Is ClearSetStatus only, user cannot modify.Once set, this can be disabled bysetting it to a null string, or by clearingpassword jumper on system board(see Configuring Mother BoardJumpers in this Chapter).SupervisorPassword IsClearSetStatus only, user cannot modify.Once set, this can be disabled bysetting it to a null string, or by clearingpassword jumper on system board(see Configuring Mother BoardJumpers in this Chapter).Set UserPasswordUp to eightalphanumericsSupervisor password controls accessto the setup utility.When Enter is pressed, the user isprompted for a password; press Escto abort. Once set, this can bedisabled by setting it to a null string, orby clearing password jumper onsystem board (refer to ConfiguringMother Board Jumpers in thischapter).Set SupervisorPasswordUp to eightalphanumericsWhen the key is pressed, theuser is prompted for a password;press ESC key to abort. Once set, thiscan be disabled by setting it to a nullstring, or by clearing password jumperon system board (refer to ConfiguringMother Board Jumpers in thischapter).Password on boot [Disabled]EnabledDisables or enables password entryon boot.Fixed disk bootsector[Normal]Write ProtectWill write protect the boot sector of thehard drive to prevent viruses fromcorrupting the drive under DOS if setto write protect.Diskette access User[Supervisor]Controls access to the floppy diskdrive.[ ]: Factory-set
