5-8 Installing the Operating System with Express SetupInstalling the Windows Server 2003This section describes on how to setup the system using Express Setup.Prepare Configuration Diskette. You can operate the installation if you do not have ConfigurationDiskette specified in advance, but one floppy disk formatted by MS-DOS 1.44MB is necessary alsoin such case. For Configuration Diskette, use the blank disk in NEC EXPRESSBUILDERpackage or prepare other floppy disk personally.IMPORTANT: If you modified the system configuration, execute "SystemUpdate". If you want to modify or add Graphics Accelerator Driver or thedrivers of Network Adapter and so on, see Appendix D.1. Turn the power of peripheral device on, and then turn on the server.NOTES: If you operate installing Windows Server 2003 with MO deviceconnected, the installation may not be completed normally. In suchcase, detach MO device and then re-install the system from thebeginning. Connect the hard disk drive that OS is not going to be installedafter installing OS. If you create multiple logical drives in your system, refer to "Re-installing the operation system when multiple logical drives exist"(Appendix D).2. Insert NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive of the server.3. Ensure that the floppy disk drive is empty.4. Press the RESET switch or press Ctrl, Alt, and Delete to reboot from the NECEXPRESSBUILDER. (You may also turn off and then on again to reboot the server.)The system will boot from the CD-ROM and NEC EXPRESSBUILDER starts.5. Click [Express Setup]."Note" will be displayed.6. Read the instruction carefully and click [OK].The message "Insert Configuration Diskette" appears.7. Insert "Configuration Diskette" into the floppy disk drive and click [OK].NOTE: If you do not have "Configuration Diskette", insert a blankfloppy disk formatted by 1.44MB into the floppy disk drive and click[OK].
