E-4 Installing Windows 2000INSTALLING WINDOWS 2000Preparations for Installation NEC EXPRESSBUILDER CD-ROM Microsoft Windows 2000 Server (CD-ROM) Windows 2000 Service Pack (CD-ROM) User's Guide Getting Started Windows 2000 OEM-DISK for NEC EXPRESSBUILDERCreating "Windows 2000 OEM-DISK for NEC EXPRESSBUILDER"Before installing, create Windows 2000 OEM-DISK for NEC EXPRESSBUILDER.NOTE: If you have already "Windows 2000 OEM-DISK for NECEXPRESSBUILDER" for NEC Express5800 Server which you aregoing to install Windows 2000, you do not need to create it again.You can create Windows 2000 OEM-DISK for NEC EXPRESSBUILDER with the following twoprocedures. Create from the menu which appears when running NEC Express5800 Server with NECEXPRESSBUILDER.If you have only NEC Express5800 Server to create Windows 2000 OEM-DISK for NECEXPRESSBUILDER, use this procedure.If Windows Server 2003 or Windows 2000 can be operated on NEC Express5800 Server,you can use the other procedure described later.Follow the steps below.1. Prepare one 3.5-inch floppy disk.2. Turn on your NEC Express5800 Server.3. Insert the NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive of the server.4. Press the RESET switch or press Ctrl, Alt and Delete to reboot the server.(You may also turn off and then on again to reboot the server.)The system will boot from the CD-ROM and NEC EXPRESSBUILDER starts.5. Select [Create Support Disk] from [Tools].6. Select [Windows 2000 OEM-DISK for NEC EXPRESSBUILDER] from [Create SupportDisk] menu.
