Configuring Your Server 4-5Configuration ExamplesThe following describes examples of configuration required to use software-link features or forsystem operations.Time and Date SettingsYou can also change the time and date settings via the operating system commands.Select [Main] - [System Time].Select [Main] - [System Date].Link with Management SoftwareTo control power supply of the server with NEC ESMPRO Manager via the networkSelect [Advanced] - [Advanced Chipset Control] - [Wake On LAN/PME] - [Enabled].Select [Server] - [AC LINK] - [Stay Off].ATA Drive SettingsTo check the ATA drives connected with the onboard ATA channels.Select [Main] - [Primary IDE Master], [Primary IDE Slave], [IDE Secondary/Master], and[IDE Secondary/Slave].To configure the RAID drive.Select [Advanced] - [I/O Device Configuration] - [SATA Controller Mode Option] -[Enhanced] - [SATA RAID Enabled], [Enabled], and use the RAID configuration utility(see "RAID Configuration Utility" in this chapter).UPSTo link power supply with the UPS To power on the server when power is supply from the UPSSelect [Server] - [AC LINK] - [Power On]. To keep the server off-powered even when power is supplied from the UPSSelect [Server] - [AC LINK] - [Stay Off].
