Honeywell Morley-IAS ZX Series Commissioning Manual

Contents

Honeywell Morley-IAS ZX Series Commissioning Manual Manual pdf 35 page image

ZX Fire Alarm Control Panels MORLEY-IASCommissioning Manual Document No. 996-175-000-1, Revision 01 Page 31• This display shows several pieces of information. To avoid ambiguity as to what can be modified, thedisplay will flash the item that can be changed. If this item is a number and you want to change it, thensimply type the new value over the top. If the item is not numeric, then use the ‘Change’ key to makeyour change. For example.Pattern ON• On entry, the ‘to zone’ number (i.e. 80 in this example) will be flashing to show this item can bechanged, if required. To make this zone 12, enter ‘12’ using the number keys. The display will thenshow the new zone range.[ Panel in Commissioning mode ]---------------------------------------------Pattern zone MODE3 001 to 012 ON• RESULT: Sounder circuit controller A will be immediately activated if a fire is detected in zones 1, 2, 3,4, 5, 6, 7, 8, 9, 10, 11 or 12.5.4.2.2 Pattern OFF• The display will then automatically flash the next changeable item, which is the mode of operation. Asthis is not numeric, use the ‘Change’ key to change the mode. Each press of the change key will cyclethrough each of the possible operating modes for this output. For example.[ Panel in Commissioning mode ]---------------------------------------------Pattern zone MODE3 001 to 012 OFF• RESULT: Sounder circuit controller A will not be activated if a fire is detected in zones 1, 2, 3, 4, 5, 6,7, 8, 9, 10, 11 or 12.5.4.2.3 Pattern DELAY• The ‘>’ key can be used to move across the display. For example, if the mode is flashing ‘Delay’ thenthe delay period can be modified by pressing the ‘>’ key to select the delay time value. Then enter thedesired period using the number keys. The backspace ‘<’ key moves back one digit - useful forcorrecting errors when entering numbers.[ Panel in Commissioning mode ]---------------------------------------------Pattern zone MODE3 001 to 012 DELAY FOR 0010s• RESULT: Sounder circuit controller A will be activated 10 seconds after a fire is detected in zones 1,2, 3, 4, 5, 6, 7, 8, 9, 10, 11 or 12.• Delays can be set in multiples of 10 seconds up to 1800 seconds (600 seconds is the maximum timeallowed in the EN54 standard).Zone 1 Sensor 1in AlarmPatternValidatedZone 1 Call Pointin AlarmSOUNDERSONSOUNDERSOFF10 S