Navigating a Saved TrackWhen initiated, a TracBack route takes you back tothe oldest stored track log point.To use the TracBack feature:1. With the Saved Tracks Page for the track orthe Track Log open, highlight the TracBackbutton, and press ENTER to open theTracBack Page showing the entire track. Youare then prompted to select the point you wantto go back to.2. Use the ROCKER to move the pointer to thepoint on the map, and press ENTER to startnavigating the TracBack.Directionsto the firstturn3. Select either Follow Road to route back tothe selected point using available roadways,or select Follow Track to retrace your originalpath of travel. Highlight the Don’t Ask Againoption, and press ENTER if you want to usethe same option each time you use TracBack.The Map Page opens with directions to thefirst turn on the track at the top of the page.4. Move in the direction of the first turn. Whenyou reach the first turn, directions to the nextturn are shown, and so on.5. To exit, press MENU, and select StopNavigation.To create a user waypoint on a saved track:1. With a saved track shown on the map, usethe ROCKER to move the pointer to the placeon the track that you want to mark as a userwaypoint. If the pointer is placed on the mapwhere no map item is located, a prompt asks ifyou want to create a waypoint.2. Press and hold the ENTER key to open theMark Waypoint Page.3. Customize the user waypoint, highlight OK,and press ENTER to save it.0 GPSMAP 60Cx Owner’s ManualbAsIc oPerAtIon > usIng trAcKs