110 GPSMAP 3206/3210 Owner’s ManualaPPendIX > M essages and alarMsappendIXMessages and AlarmsThe GPSMAP 3206/3210 uses an on-screen message system to alert you to unitoperating characteristics. Press QUIT to acknowledge the message.Accuracy Alarm—the GPS accuracy has fallen outside of the user-set value.Alarm Clock—the alarm clock has sounded.Anchor Drag Alarm—you have drifted out of the specified distance range.Approaching Turn—you are nearing a turn in a route.Approaching —you are a specified alarm distance from adestination waypoint.Arrival At —you arrived at the destination waypoint.Battery Alarm—battery voltage has fallen below the value specified in theBattery field on the Alarms tab.Battery Voltage Is Too high—too much input voltage; the unit shuts off in 10seconds. Decrease the input voltage to less than 32 volts.Boat is not Moving Fast Enough to Calibrate—the boat is not moving fastenough for the speed wheel to provide a valid speed.Can’t Read User Card—error reading card; remove and reinsert. Contact yourdealer or Garmin Product Support if the problem persists.Can’t Read Voltages That high, limited To Top Of Range—voltage rangemust be between 10.0 and 35.0 volts for the GPSMAP 3206/3210.Can’t Read Voltages That low, limited To Bottom Of Range—voltage rangemust be between 10.0 and 35.0 volts for the GPSMAP 3206/3210.Can’t Send Waypoint—the unit cannot transmit the waypoint using the NMEAWPL sentence. Check the wiring.Can’t Unlock Maps—the data on data card is not unlocked for the unit. Contactyour dealer or Garmin Product Support.Can’t Write User Card—error reading card; remove and reinsert. Contact yourdealer or Garmin Product Support if the problem persists.Database Error—internal problem with the unit. Contact your dealer or GarminProduct Support to have the unit serviced.Deep Water Alarm—the depth changed by the amount of the Drift Alarm value.Directory Item With This MMSI Already Exists—the MMSI number is alreadyin DSC directory. Use a different number.Directory Memory is Full Can’t Create Entry—the DSC directory has reachedthe maximum of 100 contacts. Delete unneeded contacts to add new ones.Distress Call—a DSC distress call has been received. Take appropriate action.Drift Alarm—the depth has changed by the amount of the Drift Alarm value.Fish Alarm—shows an icon and a beep sounds (if enabled) when a fish isdetected. This alarm does not show a message banner.Invalid MMSI— enter a valid MMSI.lost Remote GPS Connection—there is a problem with the GPS antennawiring. Check the connections.lost Satellite Reception—the unit has lost satellite signals. Check the antennaconnections or try moving to a location with a clear view of the sky.NMEA Depth Is Below Transducer—you must enter an appropriate Keel Offsetfor the transducer.No Proximity Waypoints/Routes/Tracks/User Waypoints Found—youattempted to transfer user data from a data card that does not contain the specifiedtype of data. Make sure there is data to transfer on data card.None Found—no data matched the search criteria.
