Basic Sending Methods2-28Sending Documents2• If the machine cannot detect the size of the original correctly, the Original Size screenappears when you press (Start). Specify the size of the original manually ➞ press[OK].If there are no sizes on the screen matching the size of the original, select the sizewhose width (Y) matched the width of the original. Even if the length (X) of the sizeselected on the screen is shorter than that of the original, the machine scans all thecontents of the original (original of up to 630 mm in length) for sending.Direct SendingThe following describes the flow of sending faxes using the Direct Sending mode.IMPORTANT• You can specify only one destination at a time for the Direct Sending mode.• If an error occurs or you cancel transmission in the Direct Sending mode, you cancheck how many pages have been sent to the destination by printing thecommunication reports or using the System Monitor screen. (See “PrintingCommunication Reports,” on p. 8-9, or “Checking/Printing Communication Log,” onp. 6-9.)1 Press (SEND) ➞ place your originals.IMPORTANTYou can only send one page at a time when you place your original on the platenglass. If you want to send a document of two or more pages, place your originals intothe feeder.NOTE• For instructions on how to place your originals, see Chapter 2, “Basic Operations,” inthe Reference Guide.• If appears,follow the instructions in “Logging in to Authorized Send,” on p. 2-36.• If any of the messages below appears, follow the instructions in Chapter 2, “BasicOperations,” in the Reference Guide:- - -
