Basic Sending Methods2-24Sending Documents29 Press (Start) to start scanning your originals.To cancel scanning, press [Cancel] or (Stop).The scanned data is sent to the specified destination when scanning is complete.IMPORTANT• The machine automatically detects the size of the original when scanning it. For thesize of the original the machine can detect, see Chapter 2, “Basic Operations,” in theReference Guide.• If the machine cannot detect the size of the original correctly, the Original Size screenappears when you press (Start). Specify the size of the original manually ➞ press[OK].Sending a FaxYou can scan originals and send them as faxes. The machine provides the threemodes for sending faxes: Memory Sending, Direct Sending, and Manual Sending.■ Memory SendingAll sent originals are scanned and read into memory before they are sent. Thismeans that you do not need to stay near the machine once the originals havebeen scanned. You can start scanning documents for sending even while themachine is busy sending another document.■ Direct SendingThe machine sends each page of the document to the destination as it isscanned.Although the Direct Sending mode is slower than the Memory Sending mode,you can use the Direct Sending mode when you need to send an urgentdocument ahead of other documents stored in memory.■ Manual SendingThis mode enables you to manually send fax documents after checking that thedestination is ready to receive fax transmissions. Use this mode if the recipientdoes not have a fax machine that can receive automatically.Memory SendingThe following describes the flow of sending faxes using the Memory Sending mode.IMPORTANTThe Memory Sending mode is automatically set when:- The Delayed Send mode is used- Multiple destinations are specified- The Direct Sending mode is not used
