Important• The Media Take-up Unit cannot be used with sheets.• If you have attached the Output Stacker, always stow it before using the Media Take-up Unit. (See "Stowing theStationary Output Stacker.") ➔ P.360• Position the Basket Cloth and Basket Rod so they do not interfere with the Media Take-up Sensor. This mayimpair operation. (See "Stowing the Stationary Output Stacker.") ➔ P.360• Rolls are not cut automatically when the Media Take-up Unit is used, regardless of the Cutting Mode setting inthe printer menu or the Automatic Cutting setting in the printer driver. However, you can cut paper by pressingthe Cut button.• Color tones after printing may change during the ink drying period for some types of paper. Allow ample dryingtime before the final check of colors, and do not remove printed documents from the Media Take-up Unit toosoon.• In humid environments, documents printed using plenty of ink on relatively insubstantial media such as light-weight Canon Coated Paper may not be retracted evenly by the unit. In this case, take steps to control humidityin the operating environment, or adjust the Roll DryingTime setting so that printed documents are retracted afterthe ink has fully dried.• In humid environments, documents printed on Fabric Banner or Adhesive Synthetic Paper may not be retrac-ted evenly by the unit. In this case, take steps to control humidity in the operating environment, or adjust the RollDryingTime setting so that printed documents are retracted after the ink has fully dried.Enabling Roll Take-UpEnabling Roll Take-Up1 On the Tab Selection screen of the Control Panel, press ◀ or ▶ toselect the Settings/Adj. tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.2 Press the OK button.The Set./Adj. Menu is displayed.3 Press ▲ or ▼ to select Take-up Reel, and then press the OK button.4 Press ▲ or ▼ to select Use Take-up Reel, and then press the OK button.5 Press ▲ or ▼ to select Enable, and then press the OK button.Disabling Roll Take-UpDisabling Roll Take-Up1 Press the Cut button.2 Press ▲ or ▼ to select Yes, and then press the OK button.The mode now switches from take-up mode to regular mode.Note• The printer will also switch from take-up mode to regular mode if you lift the Release Lever and cut the rollwith scissors instead of pressing the Cut button.Enabling Roll Take-Up iPF830User's GuideHandling and Use of Paper Media take-up unit366
