If two or more machines are installed and you want to switch to another machine, click [Settings], and select the machine.Configuring Settings for MF Toolbox and the ScannerConfigure the scan settings as necessary. Configuring Scan Settings in MF ToolboxClick [Start].Scanning starts.To cancel, click [Cancel].When placing documents in the feeder in step 1When scanning is complete, the scanned document is saved to a folder on a computer or forwarded to an application.Configuring Storing Settings Specifying External Applications to Forward Scanned DataWhen placing documents on the platen glass in step 1If the scanning results are not achievedIf the expected scanning results are not achieved, for example, if the image is too dark or the color tone is different from that inthe original, you can configure advanced scan settings with ScanGear MF. Place the document again, select the [Display theScanner Driver] check box on the screen in step 6, and click [Start] to start ScanGear MF.Configuring Scan Settings in Simple ModeIf the screen shown below is displayed, you can continue scanning documents (When you can only scan one page at atime, such as when the JPEG format is specified, this screen is not displayed.)1 If there are additional pages of documents to be scanned, place the next document on the platen glass,and click [Next].Repeat this step until you finish scanning all of the pages.When there is only one page to be scanned, proceed to the next step.2 Click [Finish].When scanning is complete, the scanned document is saved to a folder on a computer or forwarded to anapplication. Configuring Storing Settings Specifying External Applications to Forward ScannedData45㻞㻝㻟㻌㻛㻌㻠㻣㻡Downloaded from ManualsPrinter.com Manuals
