8 Make your selection in the E Print Target list.9 Make your selection in the F Print Quality list.10 Access the Page Setup pane.11 Select and click a roll paper in the A Paper Source list.12 Select the paper width of the roll loaded in the printer for B Roll Width. In this case, ISO A2/A3 (420.0mm)is selected.13 Select the D Enlarged/Reduced Printing check box.14 Click G Scaling and enter 120.Note• You can specify enlargement that exceeds the paper size, but in this case, the portion off the edge of thepaper will not be printed.• If the original size after enlargement or reduction is smaller than the paper size, the original is printed inthe upper-left corner. In this case, you can center originals by selecting the J Print Centered check box.15 Confirm the print settings, and then click M Print to start printing.Note• For tips on confirming print settings, see "Confirming Print Settings ." ➔ P.270Resizing Originals by Entering a Scaling Value (Mac OS) iPF850User's GuideEnhanced Printing Options Printing enlargements or reductions82
