COPYRIGHT © 1999 CANON INC. CANON 660/2100 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)D. Selecting the Type of Message for the Printer UnitIf you have installed the PS/PCL Board to the printer unit, you must select the type ofmessage appearing on its control panel.• EUROPE for service maintenance• JAPAN not used• UNITED STATES for user maintenance• UNKNOWN not used• EUROPE2 not used• JAPAN2 not used• UNITED STATES2 for service maintenanceThe default setting is UNITED STATES (i.e., for user maintenance).To change the type of message, perform the following:CHAPTER 8 INSTALLATION8-14WorkTurn off the printer unit.Check to make sure that the jumper head isfitted to J27 of the PS/PCL Board.Install the PS/PCL Board to the printer unit.While holding down the Menu and key onthe control panel of the printer unit, turn onthe printer unit.At this time, be sure to hold down the twokeys until the message ‘START SELF-TEST’appears.Wait until the printer unit has run self diagno-sis, and indicates the message ‘VERSIONINFO’Press the Menu key several times so that themessage ‘CHANGE DEFAULT LOCALE:’appears.Press the Enter key.When ‘DEFAULT LOCALE:’ has appeared,select the item that indicates the site of instal-lation using the or key.(The currently selected item is indicated bythe asterisk * on the last digit.)RemarksIf the printer unit has started withoutdisplaying the message, turn it off, andstart with step 4.• EUROPEfor service maintenance• JAPANnot used• UNITED STATESfor user maintenance• UNKNOWNnot used• EUROPE2not used• JAPAN2not used• UNITED STATES2for service maintenanceThe default setting is UNITED STATES(i.e., for user maintenance).No.12345678Download free service manual at http://printer1.blogspot.com
