COPYRIGHT © 1999 CANON INC. CANON 660/2100 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)n Making Sure of the Change• You can start the printer unit and print a start page. (Check the name of the prod-uct, which differs according to the site of installation.)• While the machine is in ready state, remove the photosensitive drum unit, and closethe front door. If ‘INSTALL DRUM CARTRIDGE’ appears on the control panel of theprinter unit, the machine is set for user maintenance; if ‘SERVICE CALL E810’appears, it is set for service maintenance.CHAPTER 8 INSTALLATION8-15WorkAfter making the selection, press the Enterkey.The message ‘LOCALE STORED’ will appearand remain for about 1 sec, to be replaced bythe message ‘CHANGE DEFAULT LOCALE:’.Turn off the printer unit, and remove thePS/PCL Board from the printer unit.Detach the jumper head J27 of the PS/PCLBoard, and install the PS/PCL Board to theprinter unit once again.Turn on the printer unit.RemarksBe sure to detach the jumper headfrom J27, and store away the head forfuture use.No.9101112• If the jumper head is not fitted to J27, the menu for ‘CHANGE DEFAULT LOCALE:’will not appear during the above procedure.• Do not change any items except ‘CHANGE DEFAULT LOCALE:’.Caution:Download free service manual at http://printer1.blogspot.com
