79 28-0724/026.6 general TroubleshootingTroubleshooting focuses on two key areas of the dispenser, the carbonation system and theelectronics as the remainder of components such as LEV’s, ice gate, auger, etc are standardon most new Ice Combo’s.Issue Cause Resolution1. Push chute and nothinghappens.1. Dispenser not connectedto power source.2. Microswitch malfunction-ing.3. Wiring harness notplugged in.1. Connect dispenser topower source.2. Replace microswitch.3. Plug in wiring harness.2. Push chute, trap dooropens but motor does notrun.1. Wiring harness notplugged in.2. PC board malfunctioning.3. Motor malfunctioning.1. Plug in wiring harness.2. Replace PC board.3. Replace motor.3. Push chute, motor runsbut trap door does notopen.1. Solenoid not connected toPC board.2. Solenoid malfunctioning.1. Tighten appropriateretaining screws.2. Replace appropriateo-rings.4. Push chute, trap dooropens, motor runs, but noice dispenses.1. Dispenser is out of ice.2. Agitator pin is missing ordamaged.1. Fill unit with ice.2. Replace agitator pin.5. Valves do not operate. 1. Toggle switch is off.2. Transformer tripped.3. Unit not plugged in.1. Turn toggle switch on.2. Reset transformer.3. Plug in unit.6. Water in ice bin. 1. Coldplate drain isobstructed.2. Drain hose is kinked.1. Remove drain hose fromfitting to obtain access todrain.2. Replace drain hose.