lancer BEVARIETY MCY-22 Installation And Service Manual

Contents

lancer BEVARIETY MCY-22 Installation And Service Manual Manual pdf 41 page image

41 28-0724/024.4 ADJUSTINg WATER FLOWThe water flow for the Model 100 may be adjusted from 1.25 oz/sec (37 ml/sec) to 2.50 oz/sec(74 ml/sec). The water flow for the Model 145 may be adjusted from 2.0 oz/sec (59.2 ml/sec)to 4.50 oz/sec (133.2 ml/sec). The restricted flow adjustment plug (Model 100) adjusts to amaximum flow of 2.0 oz/sec (59.2 ml/sec). The restricted flow adjustment plug (Model 145)adjusts to a maximum flow of 3.3 oz/sec (97.7 ml/sec).1. Slide up I.D. panel until flow control adjustments are exposed.2. Remove nozzle by twisting counter clockwise and pulling down.3. Remove diffuser by pulling down.4. Install Lancer syrup separator (yellow) (PN 54-0031 for Model 100 valves) or Lancersyrup separator (smoke) (PN 54-0201 for Model 145 valves) in place of the nozzle.5. Activate valve to fill separator syrup tube.6. Hold a Lancer °Brix cup under syrup separator. Dispense water and syrup into cupfor two seconds. Divide number of ounces (ml) of water in cup by two to determinewater flow rate per second.7. To obtain desired water flow rate, use a screwdriver to adjust water flow control.4.5 ADJUSTINg WATER TO SYRUP °BRIXFor the Model 100, the syrup flow may be adjusted from 0.25 oz/sec (7.4 ml/sec) to 0.50oz/sec (14.8 ml/sec). For the Model 145, the syrup flow may be adjusted from 0.50 oz/sec(14.8 ml/sec) to 0.90 oz/sec (26.6 ml/sec).1. Hold the ratio cup under the syrup separator and activate valve. Check °Brix.2. To obtain desired ratio, use screwdriver to adjust syrup flow control.3. Remove syrup separator.4. Install diffuser and nozzle.5. Slide down I.D. panel.I.D. PANEL(Shown inopen position)COVER SCREWFLOW CONTROLSYRUPDecreaseIncreaseCOVERDATE OFMANUFACTURESERIES NO.NOZZLESODA LEVER(Optional)CUP LEVERFLOW CONTROLSYRUPDecreaseIncrease