43 28-0724/024.7 REMOVAL AND INSTALLATION OF FRONT SODA/WATER LEVER(Kit PN 82-1458)1. Slide I.D. panel up to expose cover mounting screw.2. Loosen cover mounting screw (do not remove) and remove cover.3. Close stems on mounting block.4. Operate valve to check for complete shutoff of water and syrup.5. Lift up wire retainer and carefully remove valve from mounting block. If LEV®,disconnect wire harness.6. Locate bottom plate plug or soda lever in bottom plate on left side of valve. Forremoval of either item, remove pin and retain for reinstallation. NOTE: If valve doesnot have pin, push bottom of plug to snap it out of position.7. To remove existing soda lever, slide lever behind vertical supports. Carefully pulllever down, rotating it towards the back right corner of the bottom plate. Then slidelever out of the slot.8. To install the front soda/water lever, first position the lever so that the contact padfaces towards the rear of the valve.a. Insert the front soda/water lever through the bottom plate and rotate thelever to the left until the contact pad is facing forward and the extension is positionedover the paddle arm on the left.b. To install spring, press stud pin into hole on upper body and fit one end ofspring into outer groove of stud pin. Fit other end of spring into hole on top of frontsoda/water lever. Install pin.9. Install diffuser and nozzle.10. Install valve on mounting block and latch wire retainer.11. If LEV®, reconnect electric wire harness.12. Push soda lever back and check for soda/water flow.13. Attach appropriate label to push pad on front soda/water lever.14. Install cover and tighten cover screw.15. Slide down I.D. panel.4.8 REMOVAL AND INSTALLATION OF FLOW CONTROLS1. Slide I.D. panel up to expose cover mounting screw.2. Loosen cover mounting screw (DO NOT REMOVE) and remove cover.3. Close stems on mounting block.4. Operate valve to check for complete shutoff of water and syrup.FRONTSODA/WATERLEVERSTUD PINSPRINGPINFRONTSODA/WATERLEVER