lancer BEVARIETY MCY-22 Installation And Service Manual

Contents

lancer BEVARIETY MCY-22 Installation And Service Manual Manual pdf 26 page image

2628-0724/025. Mix the cleaning solution. Put a portion of the solution into a spray bottle. Soak thelower chute in the remaining solution.6. Spray the upper chute with the cleaning solution.7. With a soft sponge, clean the inside of the upper and lower chutes.8. Rinse the lower chute thoroughly.9. Dry the lower chute thoroughly.10. Empty the cleaning solution from the spray bottle, then refill with plain water. Rinsethe upper chute thoroughly.11. Dry the upper chute.12. Reinstall the lower ice chute onto the upper chute, then reinstall the spring.13. Reinstall merchandiser.14. Reconnect power to the dispenser.2.5 ICE BIN CLEANINg - PERFORM AT START UP AND MONTHLY1. Disconnect dispenser from power source.2. Remove top cover.3. Remove agitator pin from agitator shaft (see photo below). Slide agitator shaftrearward out of motor shaft and pull out of rear bearing to remove.4. Remove dispensing wheel from motor shaft by sliding rearward.5. Remove dispensing wheel shroud.6. Remove splash plate assembly by lifting it up and out from the dispenser face.7. Using cleaning solution described in Section 2.2 and a clean cloth or soft brush,clean all removable parts, sides of ice bin, ice chute, and surface of aluminumcasting.8. Repeat Step 7 for all exterior surfaces of the dispenser.9. Using hot water, thoroughly rinse away the cleaning solution.10. Wearing sanitary gloves, soak a clean cloth towel in sanitizing solution described inSection 2.2, and wash all surfaces of removable parts, sides of ice bin, ice chute,and surface of aluminum casting.11. Using hot water, thoroughly rinse away the cleaning solution.12. Repeat Step 10 for all metal and plastic surfaces (but not labels) of the dispenserexterior.13. Wearing sanitary gloves, reassemble all removable parts. Ensure agitator clip islocked:14. Fill unit with ice and replace top cover.15. Reconnect dispenser to power source.