lancer BEVARIETY MCY-22 Installation And Service Manual

Contents

lancer BEVARIETY MCY-22 Installation And Service Manual Manual pdf 14 page image

1428-0724/021.3 UNPACKINg THE DISPENSER1. Set shipping carton upright on the floor.2. Cut band and remove.3. Open top of carton and remove interior packing.4. Lift carton up and off of the dispenser.5. Remove wood shipping base from the bottom of the dispenser. (Support dispenserwhile removing shipping base.)1.4 DRAIN SPIDERThe Drain Spider is located directly in the center of the bin under the ice shroud. The coldplatehas a cavity designed to hold the drain spider. During shipment or installation, the drain spidermay become dislodged from its original position.Prior to installing the dispenser, ensure the drain spider is in the correct position. This willprevent drain clog issues. Inspect the lower bin area and reach under the shroud to ensure thedrain spider is secure in the coldplate cutout. If the spider is not in place, proceed with thefollowing steps:1. Remove clip (2) and pin (4) from agitator bar (3).2. Remove agitator bar from paddle wheel (5).3. Remove paddle wheel.4. Remove ice shroud (1) by lifting back then out of the bin.5. Locate the drain spider and reinstall in the coldplate cavity where the drain line exits(see figure above).6. Reinstall all components. Ensure agitator clip is locked:DRAIN SPIDER