74 4 Settings on the Control PanelPCLSets the PCL emulation mode.Paper TraySpecifies the paper tray to be used for printing.Candidate values are as follows:[Auto] (default)This searches for the tray loaded with the paper size specified in [Output Size] andautomatically feeds paper from it.[Tray 1][Tray 2][Tray 3][Tray 4][Tray 1 (Bypass)]Important• If any tray from [Tray 1] to [Tray 4] is selected, the paper size loaded in the tray will become the papersize for printing.Note• If [Auto] is selected and paper of the same size is loaded in multiple trays in the same direction, paperwill be fed from the tray specified as higher priority in [Tray Priority] under [Printer Settings] of [AdminMenu]. The default of [Tray Priority] is Tray 1 (highest priority) > Tray 2 > Tray 3 (optional) > Tray 4(optional) (lowest priority). If paper of the same size is loaded in multiple trays in different directions,paper loaded in landscape direction will be used first.• [Tray 3] and [Tray 4] will not be displayed when those optional trays are not installed.• [Tray 1 (Bypass)] will be displayed only when the bypass tray (optional) is installed. If it is displayed, youcannot specify [Tray 1].Output SizeSpecifies the paper size to be printed.Candidate values are as follows:[A4][A3] [A5] [B4] [B5][8.5×14] (Legal)[8.5×11] (Letter)Output Size (Bypass)Specifies the paper size to be loaded in the bypass tray (optional).Candidate values are as follows:[A4] (default)[A3] [A5] [B4] [B5][8.5×14] (Legal) [8.5×11] (Letter) [8.5×13] [11×17] [7.25×10.5]Output TraySpecifies the output tray for printed paper.[Center Tray] (default)[Rear Tray][OffsetCatchTray]Note• [Rear Tray] is available only when the rear tray (optional) is installed.• [OffsetCatchTray] is available only when the offset catch tray (optional) is installed.
