112 5 TroubleshootingCorrupt HD filePress Set keyWhen the hard disk (optional) is installed, the printer assumes that data in the harddisk is corrupted if power is cut off when the printer is in use.Press the button on the control panel. The hard disk will be initialized.Important• Initializing the hard disk will delete data for registered forms, logos and secureprint. If the PostScript software kit (optional) is installed, PostScript download fontswill also be deleted.Corrupt Log filePress Set keyWhen the hard disk (optional) is installed, the printer assumes that data in the harddisk is corrupted if power is cut off when the printer is in use.Press the button on the control panel. The log file will be initialized.Important• It takes several tens of seconds to initialize the log file. Do not switch off the powerof this printer when initialization is in progress.Ejecting...xxxx Tray *The printer is forcedly outputting the remaining print data. The printer cannot receiveany print data from the computer during processing.Empty CenterOutput TrayThe center output tray is full. Remove paper from the center output tray.Ended with Errorxxx-xxxAn error has occurred and printing does not finish successfully.Check the error code “xxx-xxx” displayed in the screen and perform the appropriateprocedures.Refer to• “List of Error Codes” (P. 115)Incorrect papertype ReselectSet to PrintStop to CancelPaper of the type specified under [Specify Paper Type] in the printer driver is notloaded in the trays. Press the button on the control panel to print onpaper of another type or press the button to cancel the job.InitializingPostScriptThis is displayed when the PostScript software kit (optional) is installed and indicatesthat the printer system is being initialized. This is displayed when the power isswitched on or the system is reset.Load Tray *xxxx XXXXThere is no paper whose size and orientation is “xxxx” and whose paper type is“XXXX” left in the tray.Load paper whose size and orientation is “xxxx” and whose paper type is “XXXX”into the tray *.Refer to• “Loading Paper in a Paper Tray” (P. 59)Lower RearOutputTray leverSince the rear tray is specified as the output destination, the printer cannot output tothe center output tray. Push down the rear output tray lever and change the outputdestination to the center output tray.Off-lineOff-lineData in memoryThe printer is offline as the button has been pressed. To cancel the offlinestatus, press the button again.Note• The printer cannot receive any print data from the computer while it is offline.Open Cover A or BClear JamPaper jam has occurred around the printer fuser unit.Open cover A or B of the printer to remove the jammed paper.Refer to• “5.1 When Paper Jams” (P. 101)Message Condition/Reason/Action
