01/024-46 8825/8830 PrinterREP 9.1, REP 9.2Repairs and Adjustments11. (Figure 6): Carefully remove the Drum Assembly from the Printer and place it, Gear Boxdown, in a safe place on the floor.Figure 6 Removing the Drum Assembly12. Using the Handles, lift the Xerographic Module out of the Printer and place it on a stable,flat surface.REP 9.2 Drum AssemblyParts List on PL 9.2WARNINGSwitch off the Main Power Switch. Disconnect the Power Cord.Removal1. Loosen the screws and open the Rear Door.2. Raise and latch the Top Cover.3. Lift and rotate the Image Module to the Service Position.4. Lower the Media Transport Cover.NOTE: Figure 1 shows only the Front Support Bracket.Gear BoxDrum Assembly
