01/024-26 8825/8830 PrinterREP 8.5Repairs and AdjustmentsREP 8.5 Pressure PlatesParts List on PL 10.3WARNINGSwitch off the Main Power Switch. Disconnect the Power Cord.NOTE: The art used for this procedure was developed for previous products and may notmatch the 8825/8830 configuration exactly.Removal1. Latch the Xerographic Module at the Service Position (REP 9.2).2. Remove the Media Transport Assembly (REP 8.1).3. Remove the Fabric Guide (REP 8.9).CAUTIONBe sure to push the Buckle Switch Actuator down while starting to remove the Upper PressurePlate in order to prevent damage to the actuator.4. (Figure 1): Remove the Upper and Lower Pressure Plates.Figure 1 Removing the Pressure PLates1Push the BuckleSwitch Actuatordown (not shown)2Remove the UpperPressure Plate3Remove the LowerPressure Plate
