01/024-478825/8830 Printer REP 9.2Repairs and Adjustments5. (Figure 1): Prepare the Front and Rear Support Brackets for raising the Xerographic Mod-ule to the Service Position.Figure 1 Preparing the Support BracketNOTE: The latches that secure the Xerographic Module to the Printer Frame are spring-loadedand will automatically engage the holes. The latches have a 1/4 turn lockout feature that maybe used to prevent actuation during reinstallation of the Xerographic Module. When performingthe following step, ensure that the spring-loaded feature is active.6. (Figure 2): Using the handles on the Web Oiler Assembly, rotate the Xerographic Module90 degrees so that the latches lock into the holes in the frame.Figure 2 Latching the Xerographic Module at the Service PositionNOTE: In the following steps, “Left” and “Right” describe machine locations as observed whenyou are facing the Xerographic Module at the left side of the Printer.1Lift the bracket at thetab in order to discon-nect the spring2Pull the spring awayfrom the shaft3Push the bracket downto the horizontal posi-tion5Using the handles on the WebOiler Assembly, pull back theXerographic Module so that thegroove on the shaft is capturedby the Support Bracket ((Frontand Rear)Tab4Perform Steps 1through 3 for the RearSupport BracketHandles1Rotate the XerographicModule 90 degrees2Ensure that the Xerographic Module is latched tothe frame
