01/024-438825/8830 Printer REP 9.1Repairs and AdjustmentsREP 9.1 Xerographic ModuleParts List on PL 9.1, PL 10.1WARNINGSwitch off the Main Power Switch. Disconnect the Power Cord.Removal1. Loosen the screws and open the Rear Door.2. Raise and latch the Top Cover.3. Lift and rotate the Image Module to the Service Position.4. Lower the Media Transport Cover.NOTE: Figure 1 shows only the Front Support Bracket.5. (Figure 1): Prepare the Front and Rear Support Brackets for raising the Xerographic Mod-ule to the Service Position.Figure 1 Preparing the Support Bracket6. Remove the Web Oiler Assembly (REP 10.7).1Lift the bracket at thetab in order to discon-nect the spring2Pull the spring awayfrom the shaft3Push the bracket downto the horizontal posi-tion4Disconnect A23P15Perform Steps 1through 3 for the RearSupport BracketTab
