01/026-4 8825/8830 PrinterTo Exit The Diagnostic Mode, Input Diagnostic TestGeneral ProceduresTo Exit The Diagnostic ModeEnter the test [0361] or switch the printer power off, wait 5 seconds, then switch it on.Input Diagnostic Test Procedure1. Enter the Diagnostic Mode2. Enter the Test Code3. Press the Enter button to begin the test.4. Manually operate the component that is to be tested.5. The condition of the component will be indicated in the message display window. Thestate of the component is indicated by a 0 for low state and a 1 for high state6. Press the Exit button to stop the diagnostic test7. Press the Exit button again to clear the chain
