01/022-178825/8830 Printer Generic Clutch RAPStatus Indicator RAPsGeneric Clutch RAPInitial ActionsNOTE: This procedure can be used to check any clutch. Due to the generic format of this RAPthere will be no specific ADJ, PL or Diagnostic codes identified.Procedure( Figure 1): Enter DIAGNOSTICS (General Procedures). Enter code [xxxx to test the Clutch(Refer to appropriate BSD for the specific code). Actuate the Clutch. The Clutch energizes.Y NDeactuate the clutch. There is +26 VDC at J209-12 (use the actual connector/pinnumber on the BSD) on the Driver PWB (A2).Y NCheck the wire for an open circuit. If the wires are good, replace the Clutch (PL X.X).Actuate the Clutch. The voltage decreased to approximately 0 VDC.Y NReplace the Main PWB (PL X.X).Check the adjustment of the Clutch (ADJ X.X). If the adjustment is good, replace theClutch (PL X.X).The Clutch and its circuit appear to be operating normally. Check the adjustment or alignmentof the Clutch.Figure 1 Clutch (Generic)
