01/024-40 8825/8830 PrinterREP 8.16Repairs and AdjustmentsREP 8.16 Exit RollParts List on PL 8.4WARNINGSwitch off the Main Power Switch. Disconnect the Power Cord.Removal1. Latch the Xerographic Module at the Service Position (REP 9.2).2. Remove the Media Transport Assembly (REP 8.1).3. Remove the Media Exit Switch (REP 8.2).4. (Figure 1): Remove the Exit Roll from the Front Pivot Assembly.Figure 1 Removing the Exit Roll1Remove the E-ring3Remove the E-ring2Remove the belt, the E-ring andthe pulley4Remove the Exit Roll by moving it to theright until it is free of the bushing on theleft side, then lift the roll out of the FrontPivot AssemblyExit RollFront PivotAssemblyLeft Side
