GUI System Tab789By default, all of the Status LEDs are selected, and considered to be Conditional.However, this feature allows the user to only monitor specific Errors or Alarms orspecific sections of Errors and Alarms for each Protocol Processor in the All Test Statuswindow by un-selecting certain LEDs. If a check box is unselected (unchecked), thoseErrors and Alarms will be ignored when displaying the Summary LED on All Test Statusscreen. Thus causing the Summary LED to not turn Red when any non-selected StatusLEDs in the LED Status Indicator section do turn Red.Multi-Page DisplayWhen a unit is equipped with more than 12 Protocol Processors or Port numbers, the AllTest Status screen will be split into multiple groups. The All Test Status button willindicate the group being displayed, i.e. All Test (1 to 12), All Test (13 to 24), and soon. Select the All Test Status button again to advance to the next group.All Ether PortsMPA units configured for Packet testing on more than one port or tab can operatemultiple Ethernet tests simultaneously. The All Ether (Ethernet) Ports screen allows theuser to observe, at a glance, results and statistics of all simultaneous tests.If the unit is not configured to support any Packet testing, the "All Ether Ports"button will be grayed out.To view the All Ether Ports screen, select under the System Tab.MPA_e_manual_D07-00-129P_RevA00
