Common Function Buttons54• Select the Stop common function button located at the bottom of the touchscreen.To restart test activity and statistic reporting, select the Restart button.Restarting a TestThe Restart common function button is used to initiate the following test activities:• Clears and resets error, alarm, and event activity counters, statistics, and LEDsfor the current protocol processor.• Restarts monitoring for error, alarm, or event activity that was stopped using theStop button.• Elapsed Time counter resets to 000 Days, 00 Hours, 00 Minutes, and 00Seconds, and then begins to increment after the Restart finishes.To restart a test or reset statistics:• Select the Restart common function button located at the bottom of the touchscreen. Configured testing on the current protocol processor is restarted.Presets FunctionThe Presets function provides a quick and convenient way to set up the system foroperation. Using Presets involves selecting a starting protocol and its interface, andthen making an internal connection to another protocol, such as Add/Dropping fromOTN to a lower SONET/SDH mapping.To set up a connection using the Presets function:1. Select Presets from the Common Function Buttons row.2. Select Interface. All line interfaces available for your unit appear.3. Select an interface as a starting point.4. Select Configuration. The protocols available for the selected interface appear.5. Select a protocol to connect to the interface. If required, select theConfiguration button again to create additional connections.MPA_e_manual_D07-00-129P_RevA00
