Remote Client Application36• USB flash drive (shipped with the MPA system), or web browser (if installing fromthe DLI web site) for software installation.• A standard 10/100/1000BaseT Ethernet cable for connectivity between the unitand the network.If you connect the unit directly to your PC, you will need the following:• An Ethernet network interface card installed in your PC.• Either a straight-through or a crossover Ethernet cable for connectivitybetween the MPA and the PC's network interface card.Remote Client InstallationThe Remote Client software application is a Graphical User Interface (GUI) thatconnects to the MPA via an Ethernet connection, from any Windows based PC, andallows users to remotely control the MPA test modules.The Remote Client software is supplied on the USB flash drive shipped with the MPAsystem, and can also be downloaded from our website, or provided by email uponrequest.You need to install the Remote Client application upon your first use of the MPAsystem and should upgrade to the latest Remote Client version when upgradingyour MPA to a major Feature Set change. For example, from Feature Set 7.0 to 8.0.You must be logged into your Windows based PC/Laptop with Local AdminPermissions, in order to install the Remote Client software application.To install from the supplied USB drive:1. Insert the USB drive into a standard USB port.2. Open Windows Explorer and select the USB drive to display the contents andopen the Remote Client folder.3. Double-click on SETUP.EXE to begin installing the Remote Client.MPA_e_manual_D07-00-129P_RevA00
