Protocol Tabs739The following Specific Tasks for this protocol processor are discussed:• Configuring GFP Packet Streams• Inserting GFP Errors and Alarms• Viewing GFP Error and Alarm Results• Using the Event Log• Saving and Printing Statistics and Port Settings• GFP mapping for OTU-1 and OTU-2 OTN interfaces• Configuring an RFC-2544 Test• RFC-2544 - Throughput Testing• RFC-2544 - Frame Loss Testing• RFC-2544 - B2B Burst TestingConfiguring GFP Packet Streams(Specifically for GFP Mappings and GFP-F or GFP-T modes)The Config > Set (Stream Control) screen provides the tools required to configure oredit GFP packets.To configure a packet stream:1. Configure the GFP Payload setting from the SONET/SDH tab, or the GFPMapping from the OTN tab; depending on the configured Interface.2. Select the Packet tab, then select Config and choose Set.3. Select either GFP Framed Ethernet or GFP Transparent mode.4. Make any needed changes to the PFI, EXI, PTI or UPI overhead settings, asneeded.5. Choose a Strms Pg # side tab. (Where # is either 1 or 2 depending on whichstream(s) you want to set.)6. Select a desired stream to test in the Stream Profile table. The Traffic StreamProfile dialog box appears.7. From the Traffic Stream Profile dialog box, set the parameters for the packetstream.MPA_e_manual_D07-00-129P_RevA00
