SDH Tab500Module Control PinsQSFP28 Module Control Pins can be changed when the Interface is set to None.SFP+ and SFP8 Module Control Pins are read only.Control Pin DescriptionTX_DISABLE Toggles the logical state of the TX_DIS pin state.RS0 Toggles the logical state of the Rate Select 0 bit.RS1 Toggles the logical state of the Rate Select 1 bit.TX_FAULT Reports the state of the TX_FAULT signal.MOD_ABS Reports the presence of an inserted CFP module to the Host.RX_LOS Reports if the CFP is receiving LOS on any Optical LaneI2C AccessMPA_e_manual_D07-00-129P_RevA00
