Sony DNW-A75 Maintenance Manual

Also see for 10001: Installation manual Installation manual Operation manual Maintenance manual Maintenance manual

1-26 DNW-A75/A75P1-13. Settings and Adjustment when External Equipment is Connected1-13. Settings and Adjustment when External Equipment is Connected1-13-1. Settings for Time CodeSet the TC GENERATOR switches on the upper control panel as follows.Case TC GENERATOR switch Setting RemarksWhen editing with an INT / EXT INTeditor (BVE-2000, etc.) PRESET / REGEN PRESETcapable of the 1st editFREE RUN / REC RUN FREE RUNWhen editing with direct INT / EXT INT The setup menu ITEM-610:machine-to-machine PRESET / REGEN PRESET REGEN CONTROL MODE(VTR-to-VTR)FREE RUN / REC RUN REC RUNmust be set to “AS&IN”.1-13-2. VTR Constant Values Settings of EditorSet the VTR constant values according to the table below when the editor which needs the setting of VTRconstant values is connected. Moreover, the change of VTR constant values are required when the 525/625 system is switched by setup menu of this unit.VTR CONSTANT 1 VTR CONSTANT 2Model name 525/625 Data No. Data No.1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8DNW-A75 525/60 B0 46 00 96 07 07 03 8A* 0A 07 FB 00 81 3D FF 5ADNW-A75P 625/50 B1 46 00 7D 07 07 03 8A* 0A 06 FB 00 83 4B FF 4B*: Set the data of No.8 of the VTR CONSTANT 1 to “0A” for the following editors.. BVE-900 ROM versions earlier than 1.08. BVE-600 ROM versions earlier than 1.01nWhen remote-controlling this unit by the editor, set the setup menu ITEM-401: FUNCTION MODEAFTER CUE-UP to “STOP”.