Sony DNW-A75 Maintenance Manual

Also see for 10001: Installation manual Installation manual Operation manual Maintenance manual Maintenance manual

1-5DNW-A75/A75P1-6. Rack Mounting. Attaching the inner rails4. Pull the inner rails out from the two intermediate rails.5. While pressing the stopper of the inner rail in thedirection of the arrow A in the figure, pull the innerrail out in the direction of the arrow B.6. Remove the ten screws from both sides (left and right)of the unit as shown in the figure below.7. Attach the two inner rails to both sides (left and right)of unit with the removed screws in the step (6).Tightening torque: 120 x 10_2 N . m {12.2 kgf . cm}nBe sure to use the (B4 x 6) screws when attaching theinner rail. The use other-sized screws may cause amalfunction of the unit.Outer railIntermediate railInner railStopperABB4 x 6B4 x 6Inner railInner railRack Mounting Procedure..... Removing the feet1. Set the unit with its side panel down.nLend your hand so that the lower handle does not hangdown.2. Unscrew the four screws to remove the feet from thebottom plate of the unit.3. Set the unit in a horizontal position.m. Keep these screws and the feet.When operating the unit after demounting it from therack, be sure to reattach the feet.Tightening torque: 98 x 10_2 N . m {10 kgf . cm}. Take care of the screws thread after being removed asthey differs in fitting depending on the quality of materi-als of the feet.Material of the foot ScrewRubber PS4 x 20 with washerorPS4 x 14Plastic PS4 x 20FootFoot