Copying_ 64Using a program’s settingThis option allows you to save the current settings for future use. You canalso use the previous settings from the last job.Saving Programs1. Press Copy from the display screen.2. Adjust the settings for each copy such as Paper Source, Duplex andmore in the Basic tab (see "Changing the settings for each copy" onpage 52).3. Set the copy features in the Advanced or Image tabs, if necessary (see"Using special copy features" on page 55).4. Press the Basic tab or Back.5. Enter the number of copies using the numeric keypad on the controlpanel, if necessary.6. Press Programs.7. Press Save.8. Press Program Name input area. The pop-up keyboard appears.Enter the program name you want. Press Done.You can see the values of set Programs by scrolling up or downand check the values using the up/down arrows.9. Press Save. When the confirmation window appears, the settings youset are saved. Press OK to check the list or Cancel.Loading Programs1. Press Copy from the display screen.2. Place the originals face up in the DADF or place a single original facedown on the scanner glass and close the DADF (see "Loading originals"on page 38).3. Press Programs > Load.4. Press a program name you want to use on the list.5. Press Apply.The machine is now set to copy according to the setting you selected.6. Press Start from the control panel to begin copying.Using the Quick Copy menuThe Quick Copy menu allows you to quickly set copy options withouthaving to move to a lower level menu or another tab. But, this menu doesnot provide all copy options. If you need to use other copy options, use thecopy options in the Copy menu (see "Changing the settings for each copy"on page 52 or "Using special copy features" on page 55).1. Press Quick Copy from the display screen.2. Place the originals face up in the DADF or place a single original facedown on the scanner glass and close the DADF (see "Loading originals"on page 38).3. Adjust the settings for each copy such as Reduce/Enlarge,Duplex/N-Up, Output, Paper Source, etc.You can set the default Quick Copy options from Machine Setup> Application Setting > Copy Settings from the display screen.Set the most frequently used settings.4. Enter the number of copies using the numeric keypad on the controlpanel, if necessary.5. Press (Start) from the control panel to begin copying.
