Panasonic WV-CW970 Operating Instructions Manual

Also see for Super Dynamic III WV-CW974: Product catalog Product catalog Brochure & specs Specifications Operating instructions

Contents

Panasonic WV-CW970 Operating Instructions Manual Manual pdf 47 page image

Special settings■ Using the Special Setup MenuDisplay the special setup menu from the setup menu toadjust picture quality.First, display the special setup menu.1. Display the setup menu (page 24), move the cursorto SPECIAL O, and then press the CAM (SET)button.This will display the special setup menu.* This section explains items q through t on thespecial setup menu in that order.(1) Adjusting Picture QualityUse the following procedure to adjust picture quality.1. Move the cursor to CHROMA GAIN, and then tilt thejoystick left or right to adjust the CHROMA GAIN level.2. Move the cursor to AP GAIN, and then tilt thejoystick left or right to adjust the aperture level.3. Move the cursor to PEDESTAL, and then tilt thejoystick left or right to adjust the PEDESTAL level.(2) Setting the display [DISPLAY]1. Move the cursor to DISPLAY, and then tilt the joystickleft or right to select a display setting.OFF : Pan, tilt, zoom position displays andalarm are not displayed.POSITION : Only pan, tilt and zoom are displayed.Alarm is not displayed.ALARM : Only alarm is displayed. Pan, tilt andzoom positions are not displayed. This isthe factory default setting.ALL : Pan, tilt, zoom position displays andalarm are all displayed.The names and types of displays for the alarm displayare shown in the table below.Notes:• Use a shortcut (page 52) to switch betweendisplaying or not displaying the pan, tilt, zoompositions (during pan, tilt and zoom operation)and type of alarm on the monitor screen.* The tilt position is displayed ranging from -5˚to 90˚ to -5˚.• When the Light Control is in ALC, "IRIS CLOSE"is displayed below the pan/tilt/zoom positiondisplay when the iris is completely closed.When the Light Control is in MANUAL, "IRISCLOSE" is not displayed.• Note that auto tracking alarm (page 42) cannotbe displayed.(3) Compensating for Blemishes (PIX OFF)1. Move the cursor to PIX OFF O, and then press theCAM (SET) button.This will display the PIX OFF menu. Perform thefollowing steps to perform blemish compensationon the pixels.2. Select a position that has a blemish with the PIXOFF number, and then press the CAM (SET) button.This will display the blemish compensation patternsetting screen.(1) Use the joystick to move the cross cursor ( ) tothe location of the defective pixels.(2) Move the cursor around the display until thereare no more white spots (blemishes) visible, andthen press the CAM (SET) button.This will store the blemish compensation pattern.-47-**SPECIAL SETUP**CHROMA GAINAP GAINPEDESTALDISPLAY →ALARMPIX OFFREFRESH →PUSH SETCAMERA RESET →PUSH SETSER.NO. BFB03964RET TOPwr••••I••160••I•••• 89••I••••101- +qet360°/ 90°/X001Pan positionTilt position*Zoom ratioName of display Type of alarmMOTION DET1 MOTION DET (MODE1)MOTION DET2 MOTION DET (MODE2)ALARM IN1 ALARM IN 1ALARM IN2 ALARM IN 2ALARM IN3 ALARM IN 3ALARM IN4 ALARM IN 4Type of alarmMOTION DET1