-14-1 2 3 4ON5 6 7 8DIP Switch 1 UnitNumber1 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 8DIP Switch 1 UnitNumber DIP Switch 1 UnitNumber6970717273747576777879808182838485868788899091929394951 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 8■ RS485 Communication Parameters (DIP Switch 1)Configuring DIP Switch 1 as shown below resets communication parameters to their factory default settings. You canthen change the settings as desired.Table-21 2 3 4ON5 6 7 8DIP Switch 1 Setting Description1 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 8This setting resets communication parameters to the factory default settings.BAUD RATE : 19 200 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bitBAUD RATE : 9 600 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bitBAUD RATE : 4 800 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bitON■ Procedure to setup dip switch 1(1) Turn off the camera and use DIP Switch 1 to configure RS485 Communication Parameters as shown in Table-2.(2) Turn on the camera.This applies the setting you configured in step (1).(3) Turn off the camera, use DIP Switch 1 to set the unit number (as shown in Table-1), and then turn the cameraback on again.Notes:• When using the Unit Number “1 ~ 96” setting, the unit number setting needs to be configured using the RS485SET UP menu. For details about configuring this setting, see step 2 on page 20.• Turning on power when this setting is selected causes the RS485 SET UP menu to appear during the initializationroutine.
