Panasonic WV-CW970 Operating Instructions Manual

Also see for Super Dynamic III WV-CW974: Product catalog Product catalog Brochure & specs Specifications Operating instructions

Contents

Panasonic WV-CW970 Operating Instructions Manual Manual pdf 28 page image

Camera settings■ Using the Camera Setup MenuDisplay the camera setup menu from the setupmenu (Advanced Menu) to configure camerasettings (page 27).1. Display the setup menu (page 24), move the cursor toCAMERA O, and then press the CAM (SET) button.This will display the camera setup menu.* The following sections numbered q to !3 explainhow to use each of the camera setup menu items.(1) Camera ID (CAMERA ID)See page 24 for information on the camera IDsettings method. The factory default setting is OFF.(2) Light Control (ALC/MANUAL)1. Move the cursor to ALC/MANUAL, and then tilt thejoystick left or right to toggle between ALC andMANUAL.ALC : Enables automatic lens iris adjustment inaccordance with subject brightness.Select this ALC when using SUPER-D 3.This is the factory default setting.MANUAL: Adjust the lens iris with the IRIS button onthe system controller. Fixes the lens iris.Note: The backlight compensation submenuassociated with this menu is described separatelyand should be set up after installing the camera atthe site and observing the actual site picture.2. If ALC is set in step 1, press the CAM (SET) buttonto set SUPER-D 3.SUPER-D 33 (Super Dynamic 33)When there is wide variation between the illumination oflight and dark areas of the location being monitored,the camera adjusts the lens iris in accordance with thebright areas. This causes loss of detail in dark areas.Conversely, adjusting lens brightness for the darkareas cause brighter area to become washed out.SUPER-D 3 digitally combines an image that is set upfor a clear view of bright areas with an image that is setup for a clear view of dark areas, creating a final imagethat preserves overall detail.Notes:• SUPER-D 3 is supported only when ALC isselected for light control (ALC/MANUAL).• Camera settings are limited to the following whenSUPER-D 3 is turned on.SHUTTER : OFF, AUTO (page 29)SENS UP : OFF, AUTO (page 29)• If lighting conditions cause either of the followingphenomena, turn off SUPER-D 3.(1) Screen flickering or abnormal colour(2) Digital noise in the bright areas of the screen3. Move the cursor to SUPER-D3, and then tilt thejoystick left or right to toggle between on and off.ON : Turns on SUPER-D 3. (Go to Step 6)OFF : Turns off SUPER-D 3. (Go to Step 4)This is the factory default setting.4. Move the cursor to MASK SET O, and then pressthe CAM (SET) button.This will display the mask area screen, with thecursor in the upper left cell.5. Mask the cells in the area where backgroundlighting is bright. Masking an area will cause itsbrightness level to be ignored.Use the following steps to perform masking(1) Tilt the joystick up and down, and left and rightto move the cursor to a cell you want to mask.-28-**CAMERA SETUP** 1/2CAMERA ID OFFALC/MANUAL ALCSHUTTER AUTOAGC ON(MID)SENS UP OFFSYNC INTWHITE BAL ATW1DNR LOWRESOLUTION HIGHBW MODEAF MODE AUTO Lqetuo!1wryi!0**CAMERA SETUP** 2/2ZOOM LIMIT ×30STABILIZER OFFRET TOP!2 !3Loss of detailin dark areas...Wash out ofbright areas ...Two imagesdigitally combinedto create a clearfinal image**ALC CONT**BACK LIGHT COMPSUPER-D3MASK SETLEVELRET TOPOFF•I••••• 64- +