Pin no. Power source123424 V AC LIVE24 V AC NEUTRALGroundNot useConnections-18-Alarm In/Out RatingsAlarm In : 5 V DC pull-up input. Drive capacity of atlease 0.2 mA required.OFF : 4 V DC minimum 5 V DC maximum,or openON : 1 V DC maximum or shortAlarm Out : Open collector output. 16 V DC, 100 mAmaximum drive capacityOFF : OpenON : 100 mA maximum* When connecting to an external device, set up thesystem so the ratings are not exceeded.Note: Do not turn off camera power within 30 secondsafter turning it on. Doing so can cause pan, tilt, zoom,or focus to go out of position.Precautions• The following connections should be made by qualified service personnel or system installers in accordancewith all local codes.• See the reverse side of the cover page for main lead connection.• Turn off the power at the fuse box before starting the installation work, or it so could result in fire, electric shock,personal injury, and material damage.#24(0.22mm 2)Copper wire size(AWG)Lengthof cable(approx.)(m)(ft)#22(0.33mm 2)#20(0.52mm 2)#18(0.83mm 2)20 30 45 7565 100 160 260• 24 V AC Power Supply ConnectionRecommended wire gauge sizes for 24 V AC lineAccessory Connector Information1324220 V - 240 V AC(WV-CW970)24 V AC (WV-CW974)Coaxial Cable RG-6/U (5C-2V)*224 V AC Cable for cameraRS485 Data PortTo VIDEO IN port(CAMERA IN)8P Alarm Cable (provided)4P Alarm Cable (provided)To sensor, etc.To buzzer,display device, etc.To Matrix Switcher,etc.Video OutputConnectorAlarm InputConnectorAlarm OutputConnectorTwisted Pair Cable*1(BNC)(RJ-12)RS485 Data Port Alarm Input Connector Alarm Output ConnectorT(B)T(A)R(B)R(A)RedOrangeYellowGreenDataTxDataRx(RJ-12)Alarm In 2 (Red)Alarm In 1 (Black)GND (Brown)Alarm In 3 (Yellow)Alarm In 4 (Blue)GND (Orange)GND (Light Blue or Green)GND (Violet)Alarm Out 2 (Pink)Alarm Out 1 (Grey)GND (White)GND (Light Greenor Light Blue)*1: For twisted pair cable, use shielded low-impedance cable with a thickness of at least AWG#22(0.33 mm 2).*2: Keep the overall length of coaxial cable under 1200 meters (in the case of RG-6/U (5C-2V)).For details, see the operating instructions for the Panasonic system equipment you are going toconnect.*3: Be sure to connect the grounding cable to ground.
