Using the setup menuThis manual describe procedures for operating systemcontroller WV-CU650.All setting configuration procedures start from thesetup menu. This section explains how to display thesetup menu and provides details about the menu itemsthat it contains.■ Displaying the Setup Menu● When using the WV-CU650(1) Select the camera (this camera), and themonitor where displays the setup menu.(2) Press the MENU button to display LCD MENUCAM 101.(3) Press the ENTER button or CAM (SET) button todisplay CAMERA SETUP.(4) Press the F1 button.Refer to the pages below for details.q CAMERA ID Camera ID SettingsThis pagew SCENE SELECT Scene Select SettingsPage 25e PRESET POSITION Preset Position SettingsPage 25r AUTO TRACKING Auto Track SettingsPage 41t LANGUAGE Language SettingPage 27y ADVANCED SETUP Advanced Menu SettingsPage 27■ Camera ID SettingsThe camera ID is a series of alphanumericcharacters that indicate the location of the camera.This item can be used to turn display of the cameraID on the monitor screen on or off, and to input thecamera ID.1. Move the cursor to CAMERA ID, and then tilt thejoystick left or right to toggle camera ID display onand off.2. Select ON or OFF, and then press the CAM (SET)button. The factory default setting is OFF.3. Use the joystick to move the cursor the characteryou want to input, and then press the CAM (SET)button.This will cause the selected character to appear inthe camera ID input area. Repeat step 3 as manytimes as necessary to input all of the characters forthe camera ID. (Example: DOOR)To input a blank spaceMove the cursor to SPACE, and then press theCAM (SET) button.To delete all previously input charactersMove the cursor to RESET, and then press the CAM(SET) button.To change previously input charactersUse the joystick to move the cursor to the cameraID input area. Next, tilt the joystick left and right tomove the ↑ pointer to the character you want tochange. Finally, use step 3 above to input the newcharacter.4. Move the cursor to POSI, and then press the CAM(SET) button.This will display the ID position setting menu.5. Use the joystick to select a camera ID displayposition, and then press the MON (ESC) button.This registers the camera ID display position andreturns to the camera setting menu.-24-MODEL WV-CW970 SERIESCAMERA ID OFFSCENE SELECTPRESET POSITIONAUTO TRACKINGLANGUAGE→ADVANCED SETUP yqt rweCAMERA ID---0123456789ABCDEFGHIJKLMNOPQRSTUVWXYZ().,'":;&#!?=+-*/%$SPACE---- POSI RET RESETDOOR............DOORCamera ID Input area
