-48-(3) This returns to the PIX OFF menu.An asterisk (*) to the right of a PIX OFF numberindicates that the number has a blemishcompensation pattern assigned to it.To delete a blemish compensation pattern(1) On the PIX OFF menu screen, select of thepattern you want to delete, and press the CAM(SET) button.This will display the blemish compensationpattern setting screen.(2) Press the F3 button.(3) This returns to the PIX OFF menu.This will delete the blemish compensationpattern and remove the asterisk (*) to the right ofthe applicable pattern number.(4) Adjusting the Preset Positions (REFRESH)1. To correct for camera deviation from the presetpositions during operation, move the cursor to→PUSH SET to the right of REFRESH, and thenpress the F3 button.The refresh function corrects the camera positionwhen it starts to deviate from the preset positions.(5) Returning Camera Settings to Their Defaults(CAMERA RESET)1. To reset the camera to its initial default settings,move the cursor to →PUSH SET to the right ofCAMERA RESET, and then press the F4 button.This resets the camera to it initial factory defaultsettings. Note, however, that this does not changethe camera's preset position, AUTO PAN, patrol,RS485, blemish compensation pattern andpassword settings.Also, after the camera is reset, the advanced menuis displayed, not the quick setup menu.Note: If above operations are performed while thecursor is located at any other item besidesCAMERA RESET, further menu operations maybecome impossible. If this happens, use theprocedure under "Displaying the Setup Menu" onpage 24 to re-display the menu.** PIX OFF **2* 3* 4*5* 6* 7* 89 10 11 1213 14 15 16000 000RET TOP1*
