Panasonic VL-SWD501BX Operating Instructions Manual

Also see for VL-SWD501BX: Quick start guide Quick start guide

Contents

Panasonic VL-SWD501BX Operating Instructions Manual Manual pdf 26 page image

6.6 Changing camera settingsYou can change the settings to match how the camera is used.How to change the settings (using the main monitor)1. From the top menu of the main monitor, touch ® ® [Connected devices] ® [Camera].2. Select the number (1 - 4) of the camera to be configured.3. Touch the item name, function name, and setting contents.R Operations may have to be repeated depending on the function.4. To end the operation, press .Note:R The setting function screen automatically quits if an incoming call is received or if no operations are performed forabout 90 seconds.R In the following table, < > indicates the default settings.Item name: Sensor settingsFunction name Setting contents and other informationSensor selection Heat sensor only, , External sensor only, Allsensors, Off (disables all sensors)Heat sensor detection*1 , AlwaysR Select the time period for heat sensor detection.– When [Night only] is selected, the heat sensor operates according to the settingsof [Day and night switch] (® page 26).Motion detection*1 Day only, R Select the time period for motion detection.– When [Day only] is selected, motion detection operates according to the settingsof [Day and night switch] (® page 26).Day and night switch , TimerR Select whether to automatically set the day and night switch settings or set themmanually to a preferred time.– This setting is active when the [Heat sensor detection] or [Motion detection]settings are set to [Night only] or [Day only].Auto: the camera automatically switches between night and day modes depending onthe brightness of the surrounding area.Timer: allows you to configure the time for the night.(After selecting [Timer], set the time with [+] and [–], and then touch [OK].)Time with no detection <10 seconds>, 30 seconds, 60 secondsR Select the time after an image is detected by a sensor or a monitored image isdisplayed until the sensor can make detections again.– Select a long time period if you do not want the sensor to make frequentdetections.Heat sensor sensitivity High sensitivity, , Low sensitivity, Very low sensitivity, Do not detectR If it is difficult for the sensor to make detections, select [High sensitivity]. If detectionsare being too frequently made, select [Low sensitivity] or [Very low sensitivity].Motion detectionsensitivityHigh sensitivity, , Low sensitivity, Very low sensitivityR If you want to detect small changes in motion, select [High sensitivity]. If you do notwant to detect small changes in motion, select [Low sensitivity] or [Very lowsensitivity].266. Using a camera