Panasonic VL-SWD501UBX Quick Start Manual

Also see for VL-SWD501BX: Operating instructions Quick start guide

Panasonic VL-SWD501UBX Quick Start Manual Manual pdf 1 page image

Wireless Video Intercom SystemKey Features• Wireless Handset:Check visitors on Wireless Monitor, respond promptly and talk from living room, kitchen, everywhere home and while you are doing something else. UP to 6 wirelessmonitor connectable. Max wireless range is 100m with no obstacles. You can add on repeaters expand the range. UP to 2 DECT repeater connectable.• Large Touch Panel:The main monitor has a large, 5 inch wide screen that clearly shows each visitor's face. You can simply touch the screen to activate an approximate 2x zoomhorizontally and vertically.• Electric Lock Release Support for Gate: The gate or door lock can be easily and quickly released even from the second fl oor of the house.• Wide-Angle Camera: Wide-angle lens covers approximately 170 degrees horizontally and 115 degrees vertically.• SD Card Recording:Automatically record video images of visitors to SD card. It will record up to 3,000 visitors (30 seconds per visitor). (The SD Memory Card is sold separately.)• Wireless Sensor Cameras:By installing the optional DECT Wireless Sensor Camera, you can use human (heat) and motion sensors to monitor locations that you are concerned about.UP to 4 wireless sensor camera connectable.Door Station(Doophone)VL-V554BXVL-V554UBXDECT RepeaterVL-FKD2BXLobby StationVL-V590BXVL-V590CXWirelessMonitor Station(Sub monitor)VL-WD613BXMain MonitorStation(Main monitor)VL-MWD501BXWireless Sensor CameraVL-WD812BXFor the Sub Monitor: AC adaptor × 2 (PNLV226BX [2 pin AC plug] / PNLV226E [3 pin AC plug]), Rechargeable batteries × 2, Charger × 1For the Door Station:

Mounting base × 1 & screw (3.8 mm x 20 mm) × 2, Screw (4 mm x 12 mm) × 4, Name plate × 2, Hex wrench × 1

Flush mounting box × 1, Screw (4 mm x 25 mm) × 4, Name plate × 2, Hex wrench × 1For the Main Monitor Station: Power supply unit* (VL-PS241) × 1, Mounting bracket × 1, Cable binder × 1, Screw (4 mm x 16 mm) × 2*Including AC cable × 2, Cable binder × 1, Screw (4 mm x 40 mm) × 2Wiring Schematic DiagramAccessory InformationOptional Accessories Relative ProductUp to 20 MainmonitorsconnectablePOWER SUPPLY UNITDOORPHONE 1MAIN MONITORDOORPHONE 2220-240 V ACConnection device for option output (A contact)• When using an optional lobby station, this terminal is used by the lobby station. (In this case, connectiondevices for option output (A concatc) cannot be connected.)NP: Non-polarised12 V AC/DC12 V AC/DCElectric lockElectric lock(Optional lobby station can be connetcted.)24 V DCABDCCNP NPNPNPNPNPPowersupplyPowersupplyMAIN MONITOR STATION LOBBY STATIONElectric lock30 V AC/24 V DCNPNPNPPowersupplyWire type and lengthWiring run Wire type*1Diameter Length (Max.)Main monitor – Doorphoneφ 0.65 mm 22 AWG 100 mφ 1.0 mm 18 AWG 130 mφ 0.5 mm CAT 5 50 mMain monitor – Power supply unit φ 0.65 mm 22 AWG 10 mφ 1.0 mm 18 AWG 20 mDoorphone – Electric lock*2 φ 0.5 mm - φ 1.2 mm (24 AWG - 17 AWG) According to specifi cation of connected device.Main monitor – Connection device foroption output (A contact)*2 φ 0.5 mm - φ 1.2 mm (24 AWG - 17 AWG) According to specifi cation of connected device.Wireless sensor camera –Power supply unit – φ 0.65 mm 22 AWG 50 mφ 1.0 mm 18 AWG 100 mWireless sensor camera –External sensor – φ 0.5 mm - φ 0.8mm (24 AWG - 20 AWG) According to specifi cation of connected device.Must be no longer than 20 m.*1 Type: Single-pair cable with outer sheath (jacket) Conductor: Coppersolid• A certifi ed power supply wiring has to be used with this equipment.The relevant national installation and/or equipment regulations shallbe considered. A certifi ed power supply wiring not lighter than ordinarypolyvinyl chloride fl exible wiring according to IEC 60227 shall be used.*2 When using an electric lock or a connection device for option output (Acontact), select a device that meets the following guidelines:• Electric lock connection terminal (S1/S2):- N/O dry closure contact- 12 V AC/DC, less than 1 A• Connection device for option output (A contact) terminal (OUT1/OUT2):- 24 V AC/DC, less than 0.3 A (minimum contact: 5 V DC 1 mA)VL-SWD501BX/UBXBACD

/ 2

Related manuals for Panasonic VL-SWD501BX