Panasonic VL-SWD501BX Operating Instructions Manual

Also see for VL-SWD501BX: Quick start guide Quick start guide

Contents

Panasonic VL-SWD501BX Operating Instructions Manual Manual pdf 27 page image

Function name Setting contents and other informationMotion detection range R Select the range (area) of motion detection.– By setting the areas that you do not want motion to be detected in to X, you cannarrow down the areas that motion can be detected in.Configuration1. Touch areas that you do not want motion to be detected in sothat X is displayed on those areas. (Touch again to removeX.)2. Touch [Configure].Recording beforedetection<1 second before>, 2 seconds beforeR Select to start recording 1 or 2 seconds before a sensor detection is made.See page 23 for information about recording intervals and sensor detectionrecordings.Check sensors Heat sensor, Motion detection, External sensorR You can check the operations of each sensor when setting the camera, or at anyother time.– Select the type of sensor that you want to check, trigger it, and then confirm ifdetections were correctly made. (See the Installation Guide for the camera forinformation about how to check the sensors.)Recording test R Confirm if images are correctly recorded before and after images are recorded forsensor detections. (See the Installation Guide for the camera for more information.)External sensor , Break contactR When using commercially available external sensors, select the type of contactpoints used by the sensor.– Select the type of contact point according to the external sensor used and itsfunction.*1 When [Day and night switch] is set to [Timer], the configured time periods are displayed above the [Night only]and [Day only] setting buttons.Item name: Screen settingsFunction name Setting contents and other informationBrightness -3, -2, -1, <0>, +1, +2, +3R Adjust the brightness of camera images. (The higher you set the brightness, thebrighter the image.)– Make adjustments when the images are very dark or bright.Backlight compensation On, R When [On] is selected, backlight compensation is performed. However, dependingon the background of the subject, the backlight compensation may not be effective.Automatic illumination When the sensor is triggered: Enable, , DisableWhen monitoring: Enable, , DisableUneven colourpreventionOn, R Normally use this setting set to [Off]. Only set this setting to [On] if the colour incamera images is uneven. (When set to [On], the image quality may be reducedwhen it is dark.)Item name: Sound settingsFunction name Setting contents and other informationSensor trigger sound Sound type: , Sound b, Sound cVolume: , Normal, Quiet, MuteR Select the type and volume of the sound to be made by the camera when there isa sensor detection.276. Using a camera